200字范文,内容丰富有趣,生活中的好帮手!
200字范文 > 离合器打滑 cltuch slipping英语短句 例句大全

离合器打滑 cltuch slipping英语短句 例句大全

时间:2019-03-23 17:30:27

相关推荐

离合器打滑 cltuch slipping英语短句 例句大全

离合器打滑,cltuch slipping

1)cltuch slipping离合器打滑

英文短句/例句

1.Provides the remarkable oil film strength,prevented the coupling slips.提供卓越的油膜强度,防止离合器打滑。

2.A method of clutch skid test based on slip rate基于滑移率的汽车离合器打滑定量检测的一种方法

3.slip friction clutch安全打滑摩擦离合器

4.slip-jaw clutch波纹齿滑动式离合器

5.winch drum sliding clutch绞盘鼓筒滑动离合器

6.Caution: Do not get any trace of oil or grease on the friction-disk facings. Even small traces may cause clutch grabbing or slipping.注意:摩擦盘表面不能留有油迹和润滑油脂,即使是细小的油迹均可引起离合器的抖动和打滑

7.Research on Slip Control of Lock-up Clutch in Torque Converter;液力变矩器闭锁离合器滑摩控制研究

8.a friction clutch that will slip with the torque is too great.用转矩滑动的摩擦离合器。

9.Optimal Slip Control about Lock-up Clutch of Torque Converter液力变矩器闭锁离合器的最优滑摩控制

10.Study on smooth start device with hydraulic slip clutch in a mill磨矿机液压滑差离合器软起动装置研究

11.Model Parameter Identification and Sliding Mode Control of Automobile Clutch Driven Disk Test Machine离合器从动盘测试机模型参数辨识与滑模控制

12.centrifugal oil cleaner离心式润滑油清洁器

13.Turn both handles of the rotary slide valve( pos. no.15) and the clutch to the position“ normal”, and the annunciator“ pneumatic control” is lit on.转旋转滑阀手柄15和离合器手柄到正常位置,信号器“气动控制“灯亮。

14.Turn both handles of the rotary slide valve( pos. no.15) and the clutch to the emergency position, and the annunciator“ emergency” is lit on.转动旋转滑阀15和离合器手柄到应急位置,指示器“应急“灯亮。

15.overload release clutch过载离合器安全离合器

16.By placing the clutch on the driven pulley, the pulley can remain spinning even when the car is stopped.将离合器安装在从动轮上,即使停车时滑轮也能够连续旋转。

17.Experimental Study on the Influence of Four Kinds of Lubrication Oil on no Load Power Loss of Plate Friction Clutch四种润滑油对片式摩擦离合器空损功率影响的试验研究

18.clutch thrust ring离合器分离承推环, 离合器分离承力环

相关短句/例句

HVD set滑差离合器

1.The main causes resulting in poor speed smoothness of theHVD set under open-looped condition are the insufficient linearity of pressure control and the insufficient pressure stability of relief valve used for speed regulating purpose of theHVD set,and usually worked under condition of small flow rate and low oil pressure.介绍滑差离合器(HVD)的基本工作原理和结构。

3)slipring clutch滑环离合器

4)loose socket平滑离合器

5)clutch slip离合器滑移

6)sliding clutch滑动离合器

延伸阅读

滑差离合器见电磁调速异步电动机。

本内容不代表本网观点和政治立场,如有侵犯你的权益请联系我们处理。
网友评论
网友评论仅供其表达个人看法,并不表明网站立场。